Calibrator Adjustment
MC4 User Guide 103
Custom Transfer
Functions
MC4 has a pre-entered set of standard transfer functions. If however
they do not suit your needs, you can create your own transfer
functions as presented here.
In Basic Mode, custom transfer function definition can be started
from the following Display Modes (found in the
Tools
menu of
measurement Functions):
• Error % presented on page 82,
• Error in Input Units presented on page 83 and
• Error in Output Units presented on page 84.
And from the following Display Modes (always available in the
Tools
menu):
• Percentage presented on page 85 and
• Scaling presented on page 86.
And also from the
Tools
menu of the following generation/simula-
tion Function utilities:
• Stepping presented on page 73 and
• Manual Stepping presented on page 78.
One of the combos in all of the above mentioned utilities is called
Transfer Function
. The last option in the combo is
Create New
. It
opens the custom transfer function tool. If a custom transfer function
already exists, selecting it in the
Transfer Function
combo also
opens the custom transfer function tool.
In Calibration Mode, custom transfer function definition can be
started while editing instrument data. See:
• Function Data Page presented on page 163.
Just as in Basic Mode, look for a
Transfer Function
combo.
To Next Page
Loading...
