BEAMEX MC4 - Page 33

Configuration Windows
MC4 User Guide 21
Text Fields
Not highlighted:
J u s t T e s t i n g
T e x t F i e l d
Hig
h
lighted, empty:
Hig
h
lighted, non
-
empty:
J u s t T e s t i n g
Edit Mode:
B o n a F i d e
Beside the Enter key ( ), all Numeric keys set the highlighted Text
field to edit mode. The Enter key leaves the previous text available
for editing and the Numeric keys replace the old text.
During edit mode, you can use the arrow keys ( and ) and F2/ 
(= backspace) Function Key to edit the field.
Use numeric keys to add characters. Adding characters is done as
follows:
• First keypress opens a list of available characters with the first
item highlighted.
• Repeated keypresses alter the highlighted characters.
• Press the Enter key ( ) or the F3/ Select Function Key to
select a character. Additional functionality while the list of
available characters is open:
• If no key is pressed for a certain time, the Automatic
Adding utility selects the highlighted character (not
used in the list of symbols opening from the decimal
key).
• Pressing F3/ Cancel closes the list of available
characters and no character is selected.
The F3/ Menu Function Key allows you to do the following tasks:
• Select whether the added characters are:
Upper Case , Lower Case or Numbers .
• Select whether the Automatic Adding of characters is:
Fast or Slow .
• Clear the field.
• Ok for accepting the edited text.
Accept the new text by pressing the Enter key ( ) or use the
previously mentioned menu option. To discard changes, use the
F1/ Cancel Function Key.