Changing the Generated/Simulated Value
MC4 User Guide 55
Function Key opens a Manual Step configuration window. Its
functionality is described in chapter Manual Stepping on page 78.
To stop Stepping and return to Spinning, press the Enter ( ) key.
To stop Stepping and return to Basic Mode, press the F1/
Close
Function Key.
Notes.
You cannot exceed the minimum/maximum limits of a Function when
Spinning/Stepping.
The spinned/stepped value follows the resolution properties of the
generated/simulated Function.
MC4 remembers the Manual Step configuration settings for each
generation/simulation Function.
To Next Page
Loading...
