134/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
The reference point for the open position of the flat output drive is set if the signal GO_SetRef is set to
"high".
The signal cannot be applied at the ErgoSpin tool button. The signal is not to be set permanently to "high".
Job Abort Aborts a job
This signal is available in the compact system as of version V2.300, KE as of V2.400 and SE as of
V2.500 of the Rexroth Tightening System 350.
Input signal used for:
• Tightening channel: Compact system (Job Abort)
• Communication unit in single-channel operation (CH x.y Job Abort)
• Communication unit in application operation (KE Job Abort)
This signal aborts a currently running job.
Job Enable Activate job
This signal is available in the compact system as of version V2.300, KE as of V2.400 and SE as of
V2.500 of the Rexroth Tightening System 350.
Input signal used for:
• Tightening channel: Compact system (Job Enable)
• Communication unit in single-channel operation (CH x.y Job Enable)
• Communication unit in application operation (KE Job Enable)
This signal activates a job.
JobIn 0-31 Job In Bit 0-31: Job-specific input signal
This signal is available in the compact system as of version V2.300, KE as of V2.400 and SE as of
V2.500 of the Rexroth Tightening System 350.
Input signal used for:
• Tightening channel: Compact system (JobIn 0-31)
• Communication unit in single-channel operation (CH x.y JobIn 0-31)
• Communication unit in application operation (KE JobIn 0-31)
Using these signals, states can be reported by the superior controllers to the job and in this way, the job
sequence can be controlled.
JobOutRs Reset job output signals JobOut 0 - 31
This signal is available in the compact system as of version V2.300, KE as of V2.400 and SE as of
V2.500 of the Rexroth Tightening System 350.
Input signal used for:
• Tightening channel: Compact system (JobOutRs)
• Communication unit in single-channel operation (CH x.y JobOutRs)
• Communication unit in application operation (KE JobOutRs)
With the rising edge of this signal, the signals JobOut 0-31 are set to 0.
Job ResRs Resets a result
This signal is available in the compact system as of version V2.300, KE as of V2.400 and SE as of V2.500
of the Rexroth Tightening System 350.
Input signal used for:
• Tightening channel: Compact system (Job ResRs)
• Communication unit in single-channel operation (CH x.y Job ResRs
)
• Communication unit in application operation (KE Job ResRs)
To Next Page
Loading...
