Bosch Rexroth Tightening System 350 - Page 228

228/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
Max.
Maximum torque of the step
MEo
Tightening from above X X
MEo+
Upper limit for tightening from above X X
MEu
Tightening from below X X
TCl–
Lower limit for tightening from below X X
MGS
Torque threshold for gradient measurement X X
Mittel.
Average torque of the step, shows that the torque
values come from the average value monitoring
function
MM
Average torque value of the step X X
MM+
Upper limit for average torque value X X
MM–
Lower limit for average torque value X X
MP
Target function Upper torque X
MPu
Target function Lower torque X
MP&
Target function Upper relative torque X
MP&u
Target function Lower relative torque X
MR
Differential redundancy torque as floating decimal
number [Nm]
XXX
MR+
Upper limit for differential redundancy torque X X
MRS
Torque threshold redundancy monitoring X X
MSTS
Torque threshold stick slip X X
MWGS
Torque threshold total angle monitoring X X
MWS
Threshold torque angle X X
MWSP
Programmed torque threshold angle X
M[
Torque range X X
M[+
Upper limit for torque range X X
M[–
Lower limit for torque range X X
M_
Torque result as floating decimal number [Nm] X
M–
Lower torque limit [Nm] (floating decimal) X X
N
Programmed speed X
P_
Program number (0, 1, …, 48) X X X
Pri
Serial number of the primary measurement
transducer
X
QC_
Quality code X X X
QR_
Redundancy transducer ID ("0" = LT, "1" = Tran1,
"2"=Tran2, "–1" = none)
XXX
RC
Rework code X X
Red
Serial number of the redundant measurement
transducer
X
S
Step number of the results step in line [YY]/column
[b] format
XXX
SB
Stopped by; index for switch-off criterion (1 … 35) X X X
SGA
Yield point X X
SGA+
Upper limit for yield point X X
SGAP
Target function Yield point X
SK
Tightening step category (SK) X
Spindle
ID number of tightening spindle X
SST_
Tightening position X X
STS
Stick slip X X
STS+
Upper limit for stick slip X X
T_ Tightening time X X
Protocol
element
Meaning
Standard
Standard
Plus 310
Standard 350