234/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
Extended tightening step
• The selected monitoring functions and target functions are output.
• The monitoring function Time is always active and output. Additionally, up to nine other monitoring
functions can be activated and output in the results.
• Only set and actual values are output for the monitoring functions, but no other auxiliary parameters
(e. g. only torque when tightening, no flashback angles, or similar).
• Output for Standard Plus 310: The step results are only output, if the step is actually reached and
provides results.
• Output for Standard 350: Docu buffers are output even if their corresponding tightening step was
not performed. In this case, only the programmed values are output. Actual values are identified with
an *.
• The output order of the monitoring functions is always the same as illustrated in the results block (see
page 234). (The output order is independent from the programming order in the step).
Results block for standard tightening step
Table 6–17: Format description for a results block of a standard tightening step
Character position Description
0+ 10+ 20+ 30+ 40+ 50+ 60
1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0
_
Start trigger
**YYY
Y Y Y* *___CH_ o o . k______ K #_ YY
Hardware ID and channel no.
D_ YYY
Y - Y Y -YY_H_Y Y : Y Y: YY
Date, time
L_YYY
Y Y YY ____P_Y Y _ _ _______ OK
Consecutive no., program no.,
result
1
M- _ _ _ _ _ ZZ ZZZ_M__ _ _ _ _ZZZZZ_ M+_ ____ZZZ Z Z
Torque
A- __ Z
Z Z Z Z ZZZ_A__ _ ZZ ZZZZZZ_ A+_ _ZZZZZZ Z Z _ MAS____ ZZ Z ZZ
Angle
G- _ _ _
_ _ Z Z ZZZ_G__ _ _ _ _ZZZZZ_ G+_ ____ZZZ Z Z _ MGS____ Z Z Z ZZ
Gradient
_____
_ _ _ _ _____T_ _ _ _ _ZZZZZZ _ T +_____ZZ Z Z Z
Time
_____
_ _ _ _ ____MR_ _ _ _ _ZZZZZ_ MR+____ZZZ Z Z _ QR _ Y Y
Redundancy torque,
transducer ID
To Next Page
Loading...
