Bosch Rexroth Tightening System 350

To Next Page

To Previous Page

3 608 878 300 Tightening Technology | Bosch Rexroth AG 365/641

System 350 | 3 608 878 300/2019-03

Example:

Using the values from the example above, the value of the data field for revision 001 would be as follows:

01C341212 02670919 032009-01-12:14:43:5704476547

053.14.4 06 07

Meanings of the individual values:

• 01C341212 Tool number

• 02670919 : cycles

• 2009-01-12:14:43:57 date of the last check

• 476547 : Serial number

• 053.14.4 Software version1

MID 0042 Deactivate tool

MID 0043 Activate tool

Sent by: superordinate computer

The tightening channel (CS) or tightening cell (modular system) can be blocked with this command.

Note:

In the PLC assignment table, the Enable signal must be applied to the OP module (see Chapter PLC signals from

the tightening controller from page 172). As regards the compact system, the Enable signal must be applied to bit

1.0 of the OP PLC module in the PLC assignment table. As regards applications on the KE, the FO 1 Disable signal

must be applied to bit 5.1 of the OP PLC module.

Revision: 001 (supported by Rexroth OP and Rexroth OP-Ford and Rexroth OP-BMW)

Data field: is empty, 0 bytes

Possible response MID Error no. Comment

Command accepted 0005 -

Command error 0004 98 Request timeout in the control or PLC signal not

assigned in the PLC assignment table.