366/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
6.7.7.8 ID code messages
MID 0050 ID code download request
MID 0150 ID-code download request
MID 0051 ID code upload subscription
Is still supported, but if a new version is implemented, MID 0150 should be used.
Sent by: superordinate computer
Is used by the superior computer to send an ID code to the tightening controller.
Note:
OP must be configured as the ID code source.
Revision: 001 (supported by Rexroth OP and Rexroth OP-Ford and Rexroth OP-BMW)
Data field: ID code maximum of 25 ASCII characters (25 bytes). If the ID code is shorter than 25 characters, the
field will be filled with space characters.
Possible responses MID Error no. Comment
Command accepted 0005 –
Command error: 0004 08 Entry source for ID code not permissible
Sent by: superordinate computer
Is used by the superior computer to send an ID code to the tightening controller.
Note:
OP must be configured as the ID code source.
Revision: 001 (supported by Rexroth OP and Rexroth OP-BMW)
Data field:
– Nexo cordless Wi-Fi nutrunner 100 bytes (ASCII-characters)
– CS351, KE350: 64 bytes (ASCII-characters)
Unused bytes are filled with space characters.
Possible responses MID Error no. Comment
Command accepted 0005 –
Command error 0004 01
08
Invalid data
Entry source for ID code not permissible
Sent by: superordinate computer
The superior controller sends a subscription for the current ID codes with this message.
Note: -
Revision: see MID 0052
Data field: is empty, 0 bytes
Possible responses MID Error no. Comment
Command accepted 0005 –
Command error 0004 06 Activation of ID code upload already available
To Next Page
Loading...
