Bosch Rexroth Tightening System 350 - Page 367

3 608 878 300 Tightening Technology | Bosch Rexroth AG 367/641
System 350 | 3 608 878 300/2019-03
MID 0052 Upload ID code
MID 0052 revision 001
MID 0052 revision 002
Sent by: Tightening controller
Transfer the current ID code.
Note: From version V2.200, the following has to be observed: if the option Forwarding of ID-codes even from
unselected sources is activated, this message is used to transfer those ID codes that are not an active
ID-code-source.
Revision:
Number Supported by
001 Rexroth OP and Rexroth OP-Ford and Rexroth OP-BMW
002 Rexroth OP and Rexroth OP-BMW
Data field: Data 25 bytes (revision 001), 108 bytes (revision 002)
Automatic transfer of a new ID code received by the controller is only supported with the following ID code devices:
– Scanner
– FTP
– PLC 3964R
Possible response MID Error no. Comment
Upload ID code acknowledgement 0053 –
Table 6–94: MID 0052 revision 001
Parameter Comments Bytes
ID code part 1 Contains the first 25 characters of the ID code (ASCII).
The value consists of 25 ASCII characters.
ID -
Value range 0x20 – 0x7F
Presetting -
Example:
ID code part 1 1234512345123451234512345
Value 1234512345123451234512345
25
Data length revision 001
25
Table 6–95: MID 0052 revision 002
Parameter Comments Bytes
ID code part 1 Contains the first 25 characters of the ID code (ASCII).
The value consists of 25 ASCII characters.
ID 01
02
Value range 0x20 – 0x7F
Presetting -
Example:
ID code part 1 1234512345123451234512345
Value 1234512345123451234512345
25
ID code part 2 Contains the characters 26 – 50 of the ID code.
The value consists of 25 ASCII characters.
ID 02
2
Value range 0x20 – 0x7F
Presetting -
Example:
ID code part 2 5432154321543215432154321
Value 5432154321543215432154321
25