Bosch Rexroth Tightening System 350 - Page 371

3 608 878 300 Tightening Technology | Bosch Rexroth AG 371/641
System 350 | 3 608 878 300/2019-03
Controller name The second part of the channel name is used as the controller name.
The value consists of 25 ASCII characters.
ID 03
2
Value range 0x20 – 0x7F
Presetting ***
Example:
Controller name 04 tightening channel
Value Tightening channel
25
ID code Contains the first 25 bytes of the ID code.
The value consists of 25 ASCII characters.
ID 04
2
Value range 0x20 – 0x7F
Presetting -
Example:
ID code 123456
Value 123456
25
Job number Start as a single channel:
– Outside of the job sequence: Number of the selected OK/NOK
counter
– Inside of the job sequence: Number of the job
Start of the channel from the application:
– Outside the KE job sequence: 0
– Inside the KE job sequence: Number of the job
The value consists of two ASCII characters.
ID 05
2
Value range 01 – 99
Presetting -
Example:
Job number 2
Value 02
2
Tightening program number Number of the current tightening program.
The value consists of three ASCII characters.
ID 06
2
Value range 000 – 999
Presetting -
Example:
Tightening
program number
5
Value 005
3
Table 6–98: MID 0061 revision 001
Parameter Comments Bytes