Bosch Rexroth Tightening System 350 - Page 370

370/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
MID 0061 Upload last tightening results data response
MID 0061 revision 001
Possible responses MID Error no. Comment
Command accepted 0005 –
Command error 0004 09 Activation for the last tightening result already
available
Sent by: Tightening controller
Upload last tightening results data response
Note: Revision 999 is intended for superordinate computers with a limited receive capacity (small receive buffer). In
order to limit the size of the MID 0061 as much as possible, the parameter IDs that would usually be sent in the
message have been removed.
Special KE application range: If one spindle is in the “Bypass” condition, no result will be output for this tightening
channel with MID0061.
Revision: Number Supported by
001 Rexroth OP and Rexroth OP-Ford
002 Rexroth OP
003 Rexroth OP
004 Rexroth OP and Rexroth OP-BMW
005 Rexroth OP
999 Rexroth OP
Data field: Data 211 bytes (revision 001), 365 bytes (revision 002), 399 bytes (revision 003),
480 bytes (revision 004), 101 bytes (revision 999)
Possible response MID Error no. Comment
Last tightening results data
acknowledgement
0062 –
Table 6–98: MID 0061 revision 001
Parameter Comments Bytes
Cell ID This is where the 7th level of the location name is returned.
The value consists of four ASCII characters.
ID 01
2
Value range 0000 – 9999
Presetting -
Example:
Cell ID 21
Value 0021
4
Channel ID The first two characters of a channel name are used as channel ID. A
channel name consists of the channel ID and the name of the controller,
both of which are separated by a space.
The value consists of two ASCII characters.
ID 02
2
Value range 01–20
Presetting 01
Example:
Channel ID 04 tightening channel
Value 04
2