Bosch Rexroth Tightening System 350 - Page 375

3 608 878 300 Tightening Technology | Bosch Rexroth AG 375/641
System 350 | 3 608 878 300/2019-03
MID 0061 revision 002
Date/time of the last change Date and time of the last change in the tightening program settings.
The value consists of 19 ASCII characters in the format
YYYY-MM-DD:HH:MM:SS.
ID 21
2
Value range 0 – 9, "-" and ":"
Presetting -
Example:
Date/time of the
change
1/12/2009:2:43:57 PM
Value 1/12/2009:2:43:57 PM
19
OK/NOK counter status Status of the OK/NOK counter.
– 0: if not 1 or 2
– 1: Ch x.y CntOK = 1
– 2: OK counter not used (not configured)
Rexorth OP/Rexroth OP-BMW: Exception if MID61/MID65 evaluation
and batch information from application result is selected in the
configuration for Open Protocol: In application operation, the OK/NOK
counter of the application is applied (parameterized from the job).
The value consists of one ASCII character.
ID 22
2
Value range 0–2
Presetting -
Example:
OK counter
status
OK counter not used
Value 2
1
Tightening ID With an activated OP, consecutive number for each tightening result (for
further information, see MID 0064).
The value consists of ten ASCII characters.
ID 23
2
Value range 0000000000 – 9999999999
Presetting -
Example:
Tightening ID 123456
Value 0000123456
10
Data length revision 001
211
Table 6–99: MID 0061 revision 002
Parameter Comments Bytes
Cell ID This is where the 7th level of the location name is returned.
The value consists of four ASCII characters.
ID 01
2
Value range 0000 – 9999
Presetting -
Example:
Cell ID 21
Value 0021
4
Table 6–98: MID 0061 revision 001
Parameter Comments Bytes