3 608 878 300 Tightening Technology | Bosch Rexroth AG 369/641
System 350 | 3 608 878 300/2019-03
Serial numbering of the ID code sources
MID 0053 Upload ID code acknowledgement
MID 0054 Cancel upload ID code subscription
6.7.7.9 Messages on tightening results
MID 0060 Last tightening results data subscription
Table 6ā97: Serial numbering of the ID code sources
Source System 350 Decimal
number
Transferred value
in HEX
Scanner (serial interface)
X 1 0001
FTP
X 2 0002
SPS1 / RK512
X 3 0003
SPS2 / RK512
X 4 0004
PFCS 2-Port
X 5 0005
Barcode scanner at the tool / tool
scanner
X 6 0006
Open Protocol
X 7 0007
VW / Audi XML
X 8 0008
Cycle counter KE / SE / Nexo
X
1
1 With these sources, no message will be sent.
9 0009
Job / Multiple Inputs
10 000a / 000A
BMW TCP Manager
11 000b / 000B
No active ID code source
X
1
12 000c / 000C
Reserved
13 000d / 000D
Reserved
14 000e / 000E
Field bus / HMS module
X
1
000f / 000F
RPA
X 16 0010
IndraLogic
X 17 0011
Sent by: superordinate computer
Upload ID code acknowledgement
Note: -
Revision: 001 (supported by Rexroth OP and Rexroth OP-Ford and Rexroth OP-BMW)
Data field: is empty, 0 bytes
Possible response: none
Sent by: superordinate computer
Reset the subscription for the ID code that is received by the tightening controller.
Note: -
Revision: 001 (supported by Rexroth OP and Rexroth OP-Ford and Rexroth OP-BMW)
Data field: is empty, 0 bytes
Possible responses MID Error no. Comment
Command accepted 0005 ā
Command error 0004 07 Activation of ID code upload not available
Sent by: superordinate computer
Tightening results data subscription
Note: -
Revision: see MID 0061
Data field: is empty, 0 bytes
To Next Page
Loading...
