Bosch Rexroth Tightening System 350 - Page 441

3 608 878 300 Tightening Technology | Bosch Rexroth AG 441/641
System 350 | 3 608 878 300/2019-03
For target functions and monitoring functions, there may be additional specific parameters. These are
entered in the "add" table:
MF RelativeTorqueMax Monitoring function Torque relative max
MFs RelativeTorqueMax Monitoring function Torque relative max, switching
MF TorqueMinValue Monitoring function Torque min
MFs TorqueMinValue Monitoring function Torque min, switching
MF TorqueMaxValue Monitoring function Torque max
MFs TorqueMaxValue Monitoring function Torque max, switching
MF TorqueAverageValueMin Monitoring function Torque average value min
MF TorqueAverageValueMax Monitoring function Torque average value max
MF TorqueRangeMin Monitoring function Torque range min
MF TorqueRangeMax Monitoring function Torque range max
MF TotalAngleMin Monitoring function Total angle min
MFs TotalAngleMin Monitoring function Total angle min, switching
MF TotalAngleMax Monitoring function Total angle max
MFs TotalAngleMax Monitoring function Total angle max, switching
MF GradientAverageMin Monitoring function Gradient average value min
MF GradientAverageMax Monitoring function Gradient average value max
MF TighteningUpper Monitoring function Tightening from above
MF TighteningLower Monitoring function Tightening from below
MFs StickSlipMax Monitoring function Stick slip max, switching
STS+ Limit of the stick slip monitoring function
TSTS Torque threshold for stick slip monitoring function
MFs YieldPoint Monitoring function Yield point, switching
nom Set value of function
act Actual value of function
Table 6–131: Specific parameters and their meaning
Parameter
Meaning
control angle Control angle
angle threshold Set and actual value of angle counting torque threshold
gradient threshold Set and actual value of gradient measurement torque
threshold
angle global threshold Set and actual value of total angle monitoring torque threshold
torque stick slip threshold Set and actual value of stick slip torque threshold
torque redundancy threshold Set and actual value of redundancy monitoring torque
threshold
angle redundancy threshold Set and actual value of threshold angle for angle redundancy
Rupper, Mupper, n Monitoring parameters for tightening from above
Rlower, Mlower, n Monitoring parameters for tightening from below
Table 6–130: Tightening function parameters and their meaning
Parameter
Meaning