504/641 Bosch Rexroth AG | Tightening Technology 3 608 878 300
System 350 | 3 608 878 300/2019-03
6.13.2.1 Target server configuration
The configuration of the target server for data transmission is realized via the QDA configuration window.
Click on the Target server configuration button.
The configuration window of the target server provides the following elements:
"Explicit FTPS" transmission type
Directory have to start with "\". Directories have to be already available on the target server. Otherwise,
no data is transmitted.
Table 6–183: Target server configuration
Element Description
Server type Selection of the transmission type:
– Explicit FTPS
Coded data transmission via FTP.
– FTP
Data transmission via FTP.
–NFS
Data transmission via NFS.
Depending on the selection of the transmission type, the required elements are
activated for processing, see description below.
OK The changed settings are applied and the dialog window is closed.
Cancel Closes the dialog window without accepting the changes.
Table 6–184: Elements of "Explicit FTPS" transmission type
Element Description
Target server IP address of the target server.
Port TCP/IP port for data transfer.
Users User name for FTP server access.
The user name has to exist on the FTP server enabling access for data transmission.
Password Password for FTP server access.
The password has to exist on the FTP server enabling access for data transmission.
Certificate Safety certificate
Click on Selection, to select the file location of the certificate.
The certification file has to be transmitted to the hardware (KE350 or CS351). This
file has to be valid for the target server as registration would otherwise not be
possible.
Private key Key for authentication
The key file has to be transmitted to the hardware (KE350 or CS351). This file has
to be valid for the target server as registration would otherwise not be possible.
To Next Page
Loading...
