3 608 878 300 Tightening Technology | Bosch Rexroth AG 513/641
System 350 | 3 608 878 300/2019-03
nok-properties Structure of the results data record of NOK tightening:
– 0: Target values from result step
Set and actual values of the switch-off step (NOK step) are applied. Angle and
torque evaluation according to the limit violation.
– 2: Target values 0
Set values of the switch-off step (NOK step) are applied. If one of the two actual
values (torque or angle) is NOK, both actual values are set to "00000" in PFCS
output and both functions (torque and angle) are evaluation in PFCS output with
NOK.
Default setting: 0: Target values from result step
FO-IDCode-from-ApplChan Special case ID code / KE: If the results are returned on the KE in mode "fastening:
ApplChan", there is no clear assignment to a FOx. This means, a received TE
message (for the ID code) cannot be assigned in an FOx. This is realized by means
of an additional "FO-IDCode-from-ApplChan" table. The ApplChan channel
applying the ID code source for an application block is defined.
clients For each channel, a dedicated connection has to be generated.
–active
Activate (true) or deactivate (false) connection.
– ports
Selection of the connection type:
– 1-Port: Solicated port
– 2-Port: Unsolicated & solicated port
–ip
IP address of the PFCS server
– sol-port
Port number of the solicated port
– unsol-port
Port number of the unsolicated port
– pfcs-timeout
Timeout in milliseconds for ACK/NAK on transmission of results.
– torque-tools-manual-message
If the system is operated in Field bus mode, the structure of the results data
record is defined here (SMART / BASIC).
Table 6–192: Settings in the BS350 for PFCS 2-Port
Element Description
To Next Page
Loading...
