Bosch Rexroth Tightening System 350 - Page 525

3 608 878 300 Tightening Technology | Bosch Rexroth AG 525/641
System 350 | 3 608 878 300/2019-03
7.1.3.2 Modular system 350
Configuring the PLC assignment table (see page 580)
Defining the tightening program (see page 577)
Sending/saving data (see page 543)
Sequence test (see page 582)
Operating the ErgoSpin hand-held nutrunner (see page 626)
Fig. 7–1: Overview of commissioning steps for compact system CS351
For commissioning of a tightening channel with the ErgoSpin hand-held nutrunner, see Special operating
features of the hand-held nutrunner ErgoSpin/CC-ErgoSpin (page 626).
Assembling the tightening spindle (see page 525) or the ErgoSpin hand-held nutrunner (see page 526)
Inserting the control and power electronics in the BT/SB (see page 526)
Inserting the interface modules (see page 588)
Assigning the BT addresses
1
(see page 526)
Inserting the NK350(S) network couplers
1
(see page 526)
Combining multiple BT/SB
1
(see page 526)
Setting up the connections (see page 528)
Switching on the tightening cell (see page 534)
Connecting the PC (see page 536)
Installing the BS350 operating system (see page 537)
Starting the BS350, password entry (see page 538)
Configuring the tightening channels (see page 604)
Fig. 7–2: Overview of commissioning steps for the modular system