Bosch Rexroth Tightening System 350 - Page 557

3 608 878 300 Tightening Technology | Bosch Rexroth AG 557/641
System 350 | 3 608 878 300/2019-03
If the Manual option is active, system components with an electronic name plate of the tightening channel
are recognized, but mechanical components (e.g. gearbox or straight output drive) must be configured
manually.
The option Serial number monitoring is used to detect the exchange of an electronic component.
If a component is exchanged, the serial number of the connected system component deviates from the
number stored in the channel configuration and a system error is generated.
Additional function With the additional function Hand-held nutrunner it is possible to switch on the hand-held nutrunner
function in a tightening spindle configuration in which no hand-held nutrunner was inserted.
In this operating mode, recognition of play on the start switch by the user is active (see Nutrunner start
(page 624)).
The threshold from which an evaluation is performed corresponds to the entry in the field Play on start
switch, evaluation from in the start step. The default value is 5% of the tightening spindle's nominal
torque.
Tightening programs 0, 1, 2, 3, and 99 are automatically transferred from the ErgoSpin hand-held
nutrunner to the tightening controller with the additional function Use tightening programs from hand-
held nutrunner (program 99 and 0 to 3).
Attention: The corresponding programs on the tightening controller are overwritten by the BS350 or TFT
display after the error message has been acknowledged (error code 382).
Nutrunner docking is configured with the additional function Nutrunner docking, see Nutrunner docking
configuration (page 575).
Additional function for angle compensation, see Special features of ErgoSpin with angle compensation
(page 630):
• By means of Activate angle compensation, the function can be activated or deactivated. If no valid
license is available, the license is already in use or Angle correction demo period is not activated,
the checkbox cannot be enabled.
•Via Angle compensation demo period, the 30-day demo period can be activated. The angle
compensation function can now be enabled via Activate angle compensation.
With the additional function Socket tray coding, the type of coding for the socket tray is defined:
• Bit pattern
Every bit represents a slot in the socket tray. With bit coding, more than 1 slot can be displayed. At
3, for example, bit 1 and 2 are set, i.e. slot 1 and 2 in the socket tray are selected.
•Decimal
Defines the socket tray slot. For example 3 represents slot 3 in the socket tray.