Sync Overhead Monitors 17
MAINTENANCE OF OVERHEAD MONITORS
Although the monitors require very little maintenance, it is suggested that you follow the
screen manufacturer’s recommendations to keep them running at optimum performance. As
each manufacturer has their own maintenance requirements, it is impossible to give specic
recommendations for monitors supplied by a bowling center. Always check with the manufacturer of
your monitor before using any cleaning solution or glass cleaner.
In general, it is important to make sure that any vent holes are clear of obstructions and the monitors are
adjusted and cleaned for optimum readability.
General Cleaning
Exercise care when cleaning as the panel and exterior of advanced LCDs are easily scratched.
Take the following steps when cleaning.
1. Turn the monitor power off.
2. Disconnect the power cord from the product. Hold the power cable by the plug and do not touch
the cable with wet hands. Otherwise, an electric shock may result.
3. Wipe the product with a clean, soft and dry cloth.
Do not use detergents that contain alcohol, solvent or surface-active agents.
Do not spray water or detergent directly on the product.
4. Wet a soft and dry cloth in water and wring thoroughly to clean the exterior of the product.
5. Connect the power cord to the monitor when cleaning is nished.
6. Power on the monitor.
.
Vent Holes
Keep the vent holes on the back of the screen clean of dirt and dust. It is recommended to wipe holes
with a soft cloth a minimum of once per year. If using the internal cooling fan continuously, it’s
recommended to wipe vent holes a minimum of once a month.
Adjustments
Adjust the monitor’s brightness, contrast and sharpness controls to enhance readability. Refer to the
monitor vendor manual for specic adjustment procedures.
To Next Page
Loading...