Brunswick Sync - Mis-Scoring on One Lane (Non GS Pinsetter)

8 Troubleshooting
Mis-Scoring on One Lane (Non GS Pinsetter)
Is the
mis-score by
1 or 2 pins
only?
Start Here
Verify the pin
calibrations on the
Pin Setting screen
are correct
Check the Delay
and Level Settings
on the Pin Settings
screen
Check the ball
detector
alignment.
Does the Ball
Detector indicate
when the ball detect
beam is blocked?
Check the
Sweep/Rake
switch for
proper operation
Replace/Swap
the pin camera
Check the
condition of the
pins for the lane
Check for shiny
or oily spots on
the pin curtain
Check for
irregular bends
in the pin curtain
Check for
proper operation
of the pinsetter
YES
NO
NO
YES
Check the ball
detector For
adjacent lanes
Replace ball
detector
Check the Fast ball/
Slow ball Trigg and
Speed limit settings
Verify the night
bowling setting is
set correctly
Replace
Peripheral
Controller