Troubleshooting 7
Once the picture is “taken” it is analyzed by the Distribution board and compared to the calibration
parameters set on the Pin Setting Screen.
Typical causes of scoring errors are:
External Inuences
1. Pin Condition
2. Excessive reections in pit area.
3. Improper lighting.
Hardware
1. Camera or Camera Adapter board
2. Distribution PCB
3. Cabling
4. Ball Detectors
5. Sweep/Rake switch on pinsetter.
Setup
1. Pin calibration light level setting on the Pin Settings Screen
2. Time Delay settings on the Pin Settings Screen
3. Sweep/Rake switch actuator position.
4. Fast ball / Slow ball trigger times, speed limit, or ball speed calibration
To Next Page
Loading...
