When placing documents in the feeder in step 1
When scanning is complete, the e-mail is sent.
When placing documents on the platen glass in step 1
TIPS
If you always want to scan with the same settings:
Changing Default Settings
If you want to specify the e-mail sender name:
Register Unit Name (E-Mail)
LINKS
Canceling Sending Documents (E-mail/Shared Folder) (MF8580Cdw / MF8550Cdn / MF8540Cdn Only)
Checking Log for Sent Documents (E-mail/Shared Folder) (MF8580Cdw / MF8550Cdn / MF8540Cdn Only)
When scanning is complete, follow the procedures below.
1
If there are additional pages of documents to be scanned, place the next document on the platen glass,
and press
.
Repeat this step until you finish scanning all of the pages.
When there is only one page to be scanned, proceed to the next step.
2
Press <Start Sending>.
The e-mail is sent.
㻞㻥㻝㻌㻛㻌㻢㻣㻢
To Next Page
Loading...
