CI Systems ControlMaster SR-800R

Questions and Answers

F
fischeranthonyAug 12, 2025
Why does the CI Systems Measuring Instruments show 'Power Amplifier Short Circuit' error?
- D
  danielle58Aug 12, 2025
  The 'Power Amplifier Short Circuit' error on your CI Systems Measuring Instruments indicates a potential electrical short circuit either within the Black Body head or in the interconnect cable. To resolve this, fix the shorted circuit and then restart the controller.
K
Kristin JacksonAug 16, 2025
What should I do if CI Systems ControlMaster SR-800R displays 'The HEAD SELF CALIBRATION is Out of Tolerance'?
- T
  Tracy SmithAug 16, 2025
  If your CI Systems Measuring Instruments shows a 'HEAD SELF CALIBRATION is Out of Tolerance' warning, it might be due to a rapidly changing ambient temperature. First, reboot the controller. If the warning reappears, further assistance is needed.
M
Michelle OwensAug 20, 2025
What to do if CI Systems Measuring Instruments shows 'IO Port Short-Circuit' error?
- L
  Lauren WellsAug 20, 2025
  If your CI Systems Measuring Instruments displays an 'IO Port Short-Circuit' error, it means there's a short circuit in the IO output accessories or cables. To fix this, address the shorted circuit and then restart the system.
M
matthewmcfarlandAug 23, 2025
How to fix 'Could not open the Remote Communications Channel' error on CI Systems Measuring Instruments?
- J
  justinnolanAug 23, 2025
  To address the 'Could not open the Remote Communications Channel' error on your CI Systems Measuring Instruments, inspect the communication cables and restart the controller.
N
Nicholas PetersonAug 27, 2025
What to do if CI Systems ControlMaster SR-800R Measuring Instruments displays 'The Control Master cannot reach the required differential temperature (dT), because the absolute Te temperature value cannot be above XX1 degrees'?
- L
  Larry StephensAug 27, 2025
  If your CI Systems Measuring Instruments displays the warning 'The Control Master cannot reach the required differential temperature (dT), because the absolute Te temperature value cannot be above XX1 degrees', re-enter new dT values.
J
Jennifer BowenAug 31, 2025
What to do if CI Systems ControlMaster SR-800R displays 'The Control Master cannot reach the required differential temperature (dT), because the absolute Te temperature value cannot be below XX1 degrees'?
- X
  xmooreAug 31, 2025
  If your CI Systems Measuring Instruments displays the warning 'The Control Master cannot reach the required differential temperature (dT), because the absolute Te temperature value cannot be below XX1 degrees', re-enter new dT values.
C
Craig BowmanSep 3, 2025
How to solve 'Slow increment is lower than display resolution' error in CI Systems ControlMaster SR-800R Measuring Instruments?
- S
  Stephanie WolfeSep 4, 2025
  To resolve the 'Slow increment is lower than display resolution' error on your CI Systems Measuring Instruments, enter a slow increment value that is higher than the display resolution.
W
Wayne LewisSep 7, 2025
How to solve 'Stabilization window is lower than the display resolution' warning in CI Systems ControlMaster SR-800R?
- J
  Johnny RodriguezSep 7, 2025
  To address the 'Stabilization window is lower than the display resolution' warning on your CI Systems Measuring Instruments, enter a stabilization window value that is higher than the display resolution.