CI Systems ControlMaster SR-800R - Removing the Hood

CI Systems SR-800R
8.6.3 Removing the Hood
NOTE
This procedure is performed only if the optional Hood is
installed.
1. Disconnect the Gas Source from the Hood Gas Inlet (see Figure 8-12).
2. Release the four latches and remove the Hood from the Blackbody
(see Figure 8-12).
605-7040 Operation Manual
Rev D 8-21
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com