CI Systems ControlMaster SR-800R - Disconnecting the Pipes from the Blackbody; Disconnecting the Dry Nitrogen Source and Cables; Packing

CI Systems SR-800R
8.5.3 Disconnecting the Pipes from the Blackbody
1. Remove the Blackbody rear-side clamps (see Figure 8-7).
2. Release and remove the Pipes using 22 mm open-wrench (see Figure 8-6).
3. Re-install both pipe inlet caps (see Figure 8-5).
4. Re-install the Blackbody rear-side clamps (see Figure 8-4).
8.5.4 Disconnecting the Dry Nitrogen Source and Cables
1. Disconnect the Julabo Circulation System cables (see Figure 8-9):
a. Disconnect the Main Power Cable from the Mains (connected either directly
or via a 100 VAC transformer).
b. Disconnect the Julabo Controller Power Cable from the Circulator Power
cable-connector.
c. Disconnect the Julabo Control Cable from the Julabo Controller and the
ALARM cable-connector.
d. Disconnect the RS-232 Cable from the SR-800 Controller and the Julabo
SERIAL cable-connector.
2. Disconnect the Dry Nitrogen source from either the Blackbody Dry Nitrogen Inlet
(see Figure 8-1) or from the optional Hood Dry Nitrogen Inlet (see Figure 8-12).
3. Disconnect the Head cable between the Blackbody and the SR-800R Controller
(see Figure 8-1).
8.5.5 Packing
Pack the Blackbody in its original packaging (see Figure 8-2).
605-7040 Operation Manual
Rev D 8-18
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com