CI Systems ControlMaster SR-800R - Gettargetlist

CI Systems SR-800R
6.2.10 GETTARGETLIST
 Summary: This command returns the current axis's Target List. The user first
queries the number of targets that exist for the current axis and then returns the
specified Target ID and Target Name Pair. If the input operand is out of range or
if there are no targets/axis in the system, then a command operand error occurs.
Use the SetActiveAxis to select the desired axis.
 Reference Command: GetActiveAxis, SetActiveAxis
G E T T A R G E T L I S T Space nOperandVal
EOM
 Input Operand: nOperandVal
- 1 == Get number of Targets (nNumberOfTargets)
Range (1 - nNumberOfTargets) == Return the Target ID and then the Target
Name delimited by a comma.
Example
:
GetTargetList -1 == Returns a value of 33 for 33 Targets in the system
GetTargetList 5 == Returns data for target 5, T05, T05: FB 3.445 cy/mrad
 Return Values: see example above.
605-7040 Operation Manual
Rev D 6-15
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com