CI Systems ControlMaster SR-800R - Figure 3-36: Adding a New Target to the Target List

CI Systems SR-800R
7. To Add a New Target (up to 64 targets can be defined in the target list):
a. Select a target from the list (you may browse the list by using the Up / Down
buttons).
b. Press
. The following Add New Target window opens:
Figure 3-36: Adding a New Target to the Target List
c. Select the TargetID # and press . The window closes.
d. Select the target Type (see step 2 ).
e. Set the target Name (see step 3 ).
f. Define the target Size (in mm, see step 4 ).
g. Define the target Position (in Msteps, see step 5 ).
h. Press
, and confirm the modification of the Target Setup.
605-7040 Operation Manual
Rev D 3-33
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com