CI Systems ControlMaster SR-800R - SETPRESET

CI Systems SR-800R
6.2.15 SETPRESET
 Summary: This command is used to activate the requested Preset Number.
Presets can be generated by the ControlMaster (see Section 3.2.3.2: Preset Setup).
Query the ControlMaster with the GetMaxPresetCount command to find out the
current number of presets in the system. It should be done prior calling to
SetPreset. If an invalid Preset is sent, the ControlMaster responds with an
Operand Error.
 Reference Commands: GetMaxPresetCount
S E T P R E S E T
Space
PresetNumber
EOM
 Input Operand: PresetNumber - A valid Preset Number that is in the system. The
user must know in advance the current number of presets in the system (see
GetMaxPresetCount)
 Return Values: None
6.2.16 GETMAXPRESETCOUNT
 Summary: This is used to return the current number of Presets that are defined in
the controller.
 Reference Commands: SetPreset
G E T M A X P R E S E T C O U N T
EOM
 Input Operand: None
 Return Values: MaxPresetCount - The current number of Presets in the system.
605-7040 Operation Manual
Rev D 6-18
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com