CI Systems ControlMaster SR-800R - Gettemperature

CI Systems SR-800R
6.2.23 RT
 Summary: This command is used to get the current Target temperature.
 Note: An old style SR-80 command - should not be used for new applications. It is
replaced by the GetTargetTemperature command.
RT
EOM
 SR-80 command format compliance.
 Input Operand: One.
 Return Values: Current Target Temperature with 3-digit accuracy.
6.2.24 GETTEMPERATURE
 Summary: This command is used to display the current temperature of the system
depending on the current Temperature Control mode, i.e., if Mode =1, then the
returned temperature is the Absolute Temperature. If Mode = 2, then the
Differential Temperature is returned.
G E T T E M P E R A T U R E
EOM
 Input Operand: None.
 Return Values: The Current Temperature with 3-digit accuracy.
605-7040 Operation Manual
Rev D 6-22
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com