CI Systems ControlMaster SR-800R - Motion Control; Figure 3-16: Motion Control

CI Systems SR-800R
3.2.3.3 Motion Control
The Motion Control window allows you to control and select any target from the
available axes (up to four axes).
To open the Motion Control window:
From the Menu Window press
. The following window opens:
Figure 3-16: Motion Control
To select a target of an axis (AXIS#1 in this example):
1. Press the AXIS1 button (RAD8 Mets VS in this example).
- The AXIS1 button turns red.
- A list of all AXIS1 available targets is displayed at the window left pane.
2. Press the required target name (you may browse the list by using the Up / Down
buttons). The target name is displayed under the selected axis button.
3. Press
.
- The selected axis/target-wheel rotates until the required target reaches its
position.
- The axis button remains red.
4. To select a target from another axis/target-wheel repeat steps 1 - 3 , replacing
AXIS1 with another available axis.
5. In order to reset the target-wheel/axis press
. The target-wheel rotates to its
Home position, and then the selected target reaches its position.
6. To close and return to the last opened window (the Menu Window) press
.
7. To close and return to the Main window press
.
605-7040 Operation Manual
Rev D 3-18
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com