CI Systems SR-800R
The SR-800R starts to boot. Upon boot completion, the SR-800R initiates BIT (Built-
In Tests) while displaying the following Power-Up Sequence window:
Figure 3-2: Power-Up Sequence Message
If any malfunction is detected during the BIT process, a "Fail" notification is
displayed, instead of the "Pass" notification. The power-up sequence continues,
however.
Upon BIT completion and pending pre-setup of the SR-800R, the Temperature
Control window opens in either the Absolute or Differential working modes (for
step-by-step instructions on how to change the working mode, see Section 3.2.3.1:
Mode).
Figure 3-3: Absolute Mode Window Description
Blackbody
Model
Working
Mode
Temperature Scale
(Celsius or Kelvin)
605-7040 Operation Manual
Rev D 3-2
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...