CI Systems ControlMaster SR-800R - Figure 7-2: Typical Sensor Cover Removal;Installation (2 of 2); Figure 7-3: Sensor Cable-Connector (Typical)

CI Systems SR-800R
2. Carefully remove the Sensor Cover by pressing on the cover:
Figure 7-2: Typical Sensor Cover Removal/Installation (2 of 2)
4"
7"
12 ÷ 20"
3. Disconnect the Sensor male connector from the Blackbody:
Figure 7-3: Sensor Cable-connector (typical)
7 ÷ 20"
4"
605-7040 Operation Manual
Rev D 7-3
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com