CI Systems SR-800R
6.2.4 SETTARGET
Summary: This command moves the currently selected Active Axis to the desired
Target Position. Use this command to replace the SA Command for new
applications.
Note: You must not attempt to move to a new target position while the axis is in
motion. Query for motion status by using the GetAxisStatus Command.
This command replaces the SA command.
Reference Command: see SetActiveAxis GetAxisStatus.
S E T T A R G E T
Space
TargetNumber
EOM
Alternate Representation:
S E T T A R G E T
Space
TargetIDString
EOM
Input Operand: TargetNumber - this is a value between 1 and the number of
Targets/Filters/Sources on the currently selected axis. Any value out of range will
result in an invalid operand.
Alternate Representation: TargetIDString - this is the string representation of the
targets. There can be 3 types axes in any system. They are designated, (T)arget
Wheel, (F)ilter Wheel and (S)ource Stage. The target position is designated from
'01' to 'nn', i.e., the number in the system. The TargetIDString can be as follows:
• T01 to Tnn for Axis Type: Target Wheel
• S01 to Snn for Axis Type: Source Stage
• F01 to Fnn for Axis Type: Filter Wheel
• 'nn' is the number of 'targets' in the system
Note: For target numbers requiring less than 2 digits, such as target 1 to target 9,
the TargetIDString can be either T1 or T01, etc., whichever is easier to
implement.
A value out of range will result in an invalid operand.
Return Values: None
605-7040 Operation Manual
Rev D 6-10
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...