CI Systems ControlMaster SR-800R - Absolute Mode Window

CI Systems SR-800R
3.2.1 Absolute Mode Window
(See Figure 3-5)
Upon pre-settings (see Section 3.2.3.1: Mode), the Absolute Mode Window opens
immediately after powering-on the SR-800R and on completion of the SR-800R boot
process (see Section 3.1: Powering-on the SR-800R):
Figure 3-5: Absolute Mode Window
In the Absolute Mode Window you can:
 Set the temperature of the Blackbody Emitter (Te SET)
 Select a target for use during tests (TARGET).
 Select a pair of Te SET and TARGET or only Te SET from a predefined Preset
list (for detailed information on how to predefine the list, see Section 3.2.3.2:
Preset Setup).
To use the Absolute Mode Window:
1. Set the temperature of the Blackbody Emitter (default selection):
a. Press
. The Te SET button turns red and the temperature
adjustment is enabled.
To cancel press
. again.
b. To set a temperature use one of the following:
- Press on the up/down arrows:
The
buttons increase/decrease the value by 0.1°.
The buttons increase/decrease the value by 0.001°.
- Press
to execute your settings.
605-7040 Operation Manual
Rev D 3-5
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com