CI Systems ControlMaster SR-800R - IO Control; Figure 3-17: IO Control

CI Systems SR-800R
3.2.3.4 IO Control
The IO Control window allows you to control and monitor the I/O devices, connected
to the I/O connector, which is located on the rear panel of the controller.
To open the IO Control window:
From the Menu Window press
. The following window opens:
Figure 3-17: IO Control
To control and monitor up to five available Output channels:
1. To switch ON any output press .
- The Turn On button changes to Turn Off.
- The Off message changes to the
On message.
2. To switch OFF any output press .
- The Turn Off button changes to Turn On.
- The On message changes to the Off message.
If valid, you can monitor up to two Inputs:
- The
On message indicates that the input device is active
(above a predefined threshold).
- The
Off message indicates that the input device is inactive
(below a predefined threshold).
To close and return to the last opened window (the Menu Window) press
.
To close and return to the Main window press .
605-7040 Operation Manual
Rev D 3-19
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com