CI Systems SR-800R
3. To setup the Host Computer for Direct Link (in cases where there is no in-house
network and/or for security reasons):
a. From the computer Start menu select Network Connections (Start → Settings
→ Network Connections → Local Area Connection) The following window
opens:
Figure 3-43: Setting Up the Host Computer for Direct Link
b. Select the Internet Protocol (TCP/IP) and click . The Internet
Protocol (TCP/IP) Properties window opens.
605-7040 Operation Manual
Rev D 3-41
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...