CI Systems SR-800R
2. Description
This chapter describes the structure and assemblies of the SR-800R. Theories, based
on a general block diagram, are also provided in this chapter.
2.1 System Main Assemblies
The SR-800R operates as a complete stand-alone system (″Master″) or may be
integrated as part of an Electro-optics Test System (″Slave″).
The following describes the assemblies that may be part of the SR-800R System. The
assemblies are:
Figure 2-1: SR-800R Basic Configuration
Blackbody Target Wheel ControlMaster
SR-800R Controller.
Blackbodies: the SR-800R Controller can simultaneously control various models
of Blackbodies (for information on the models and their specifications, refer to the
SR-800R data sheets).
Host Computer: used for remote control of the SR-800R Controller when the SR-
800R Controller is integrated as part of an Electro-optics Test System.
Motorized Target Wheels: the SR-800R Controller can operate and control up to
four stepper-motors. One of the implementations of a motion-controlled device is
the motorized target-wheel. Several predefined target-wheels can be controlled by
the SR-800R Controller.
605-7040 Operation Manual
Rev D 2-1
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...