CI Systems SR-800R
7.3.2 2" Blackbodies
7.3.2.1 Removal
1. Disconnect the Target Sensor cable-connector (marked as TRG, see Figure 7-7).
2. Remove the Target Sensor using the Sensor Extractor Jig (the jig is supplied
with the new sensors):
Figure 7-10: Target Sensor Replacement (2" Blackbodies)
Sensor Extractor Jig
Target Sensor
NOTE
The inserted sensor is held in place by way of a built-in
magnet; therefore, a reasonable force is required to separate the
sensor from its port.
3. Store the sensor in its package to avoid damage.
605-7040 Operation Manual
Rev D 7-12
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...