CI Systems SR-800R
6.2.3 AXISHOMING
Summary: This command starts the Axis Homing Sequence. The selected axis
will rotate in a predefined direction to the Home Position and then return back to
its last position. This is used to "zero" any potential offset buildup for the
specified axis.
Note: you must wait till the Homing is completed before issuing new commands.
A X I S H O M I N G
Space
AxisNumber
EOM
Input Operand: AxisNumber - a value between 1 to 4, representing the axis to be
accessed. If no axis number is provided, then the command will default to AXIS 1.
Return Values: None.
605-7040 Operation Manual
Rev D 6-9
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...