CI Systems ControlMaster SR-800R - Figure 3-20: MRTD Test Setup (1 of 5); Figure 3-21: MRTD Test Setup (2 of 5)

CI Systems SR-800R
3.2.3.5.3 Setting-Up the MRTD Test
1. From the MRTD Test Window press . The following MRTD Test
Setup window opens (if the EFL parameter is not defined in the Axis Setup
window, this window will not open; refer to Section 3.2.3.6.1.1):
Figure 3-20: MRTD Test Setup (1 of 5)
2. To select the desired axis (Target-Wheel) select the axis from the Current Axis
pull-down list. The selected axis is displayed on the Current Axis field.
3. To setup up to five pairs of temperature and target:
a. Press the last available Step number button (#1 -
in this example).
- The Step number turns red.
- The following window opens, listing all possible 4-bar targets of the
selected target-wheel:
Figure 3-21: MRTD Test Setup (2 of 5)
605-7040 Operation Manual
Rev D 3-22
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com