CI Systems ControlMaster SR-800R - Communication Protocol

CI Systems SR-800R
6.2 Communication Protocol
Table 6-1: Communication Protocol - Commands Summary
Command Category Description Remarks
Axes:
GETAXISSTATUS Returns Axis Motion
Status.
AXISHOMING Perform Axis Homing
Sequence.
SETTARGET Move to Selected
Position in the current
selected active Axis.
Replaces SA
SA
2
Move to selected
position in Axis
See SETTARGET
SETACTIVEAXIS Sets the desired Axis to
be active for operation
GETACTIVEAXIS Get the current Active
Axis in the System
GETNUMBEROFAXES Retrieve the current
number of Axes and
their String IDs
RA
2
Retrieve the current
target position from the
selected axis
GETTARGETLIST Retrieves current Axis's
Target List
GETTARGETFREQUENCY Get the Spatial
Frequency of the 4 Bar
Target in the selected
Axis.
GETAXISEFL Get the Effective Focal
Length that the selected
Target Axis is set to.
Temperature Control:
2
: Complies with the SR-80 Command Format.
605-7040 Operation Manual
Rev D 6-4
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com