CI Systems SR-800R
7.2 Emitter Sensor Replacement
This section includes step-by-step procedures for replacing the Emitter sensor in the
following blackbody types:
4 ÷ 20" Blackbodies (see Section 7.2.1)
2" Blackbodies (see Section 7.2.2)
7.2.1 4 ÷ 20" Blackbodies
7.2.1.1 Removal
1. Remove the screws securing the Sensor Cover:
Figure 7-1: Typical Sensor Cover Removal/Installation (1 of 2)
4"
7"
12 ÷ 20"
605-7040 Operation Manual
Rev D 7-2
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...