CI Systems ControlMaster SR-800R - Setoutput; Getmode

CI Systems SR-800R
6.2.19 SETOUTPUT
 Summary: This command is used to set the state of the desired IO Output. There
are five IO Outputs that can be controlled. Before you can use these IO Outputs,
you must enable them by calling the OUTPUTENABLE command.
 Reference Command: OUTPUTENABLE
S E T O U T P U T
Space
OutputNumber
Comma
State
EOM
 Input Operand: OutputNumber - can be a value of from 1 to 5.
State - State can be either 0 for OFF (Disabled) or 1 for ON (Enabled)
 Return Values: None
6.2.20 GETMODE
 Summary: This is used to get the current the current temperature control mode.
 Reference Command: SetMode.
G E T M O D E
EOM
 Input Operand: None.
 Return Values:
• 1 = Absolute.
• 2 = Differential.
• 3 = Differential with Radiometric Offset Correction
605-7040 Operation Manual
Rev D 6-20
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com