CI Systems ControlMaster SR-800R - Figure 3-37: Target Removal; Figure 3-38: Target Type;Tuning

CI Systems SR-800R
8. To Remove an Existing Target:
a. Select a target from the list (you may browse the list by using the Up / Down
buttons).
b. Press
. A dialog-box opens prompting you to confirm the removal:
Figure 3-37: Target Removal
c. Press to confirm the removal.
d. Press
. The removed target is no longer displayed in the Select Target
list.
9. Target Tuning (fine-tuning the Positioning of the Targets on the Target-Wheel):
a. Select a target from the list (you may browse the list by using the Up / Down
buttons).
b. Press
. The following Target Tuning window opens, while the Target
Wheel rotates to the selected target position:
Figure 3-38: Target Type/Tuning
605-7040 Operation Manual
Rev D 3-34
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com