CI Systems ControlMaster SR-800R - Page 70

CI Systems SR-800R
c. Observe the FLIR video and check the actual target position. If it is far from
the desired position press the Current field and insert the estimated position
(in micro-step units), using the floating Keypad. Wait for the Target Wheel to
change its position.
d. Use the Up/Down arrows to fine-tune the position. The Target Wheel reacts
immediately.
e. Press
to verify the target new position.
f. Press to save your changes.
g. Press to return to the Target Setup window.
h. Repeat steps a - g to tune all the remaining targets.
NOTE
If each wheel plate contains only one target and target T01 is
already fine- tuned, then you can fine-tune all the remaining
targets automatically by pressing the
Adjust All
button.
NOTE
To immediately stop the Target-Wheel rotation press .
This causes an error in the absolute position of the wheel.
Therefore you have to press before continuing the
tuning process.
605-7040 Operation Manual
Rev D 3-35
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com