CI Systems ControlMaster SR-800R - SETTEMPERATURE

CI Systems SR-800R
6.2.28 SETTEMPERATURE
 Summary: This command is used to set the current temperature of the
ControlMaster. This is dependent on the current temperature operating mode, i.e.,
Absolute or Differential. If the temperature is out of the working range of the unit,
then an Operand Error will occur.
 Note: This command replaces the ST command for new applications.
 Reference Commands: GETTEMPERATURERANGE, SETMODE.
S E T T E M P E R A T U R E
Space
TemperatureValue
EOM
 Input Operand: TemperatureValue - This is the desired set point value of the
temperature. It is a numeric value with up to 3-digit decimal point accuracy.
 Return Values: None.
6.2.29 ST
 Summary: This command is used to set the current temperature of the
ControlMaster. This is dependent on the current temperature operating mode, i.e.,
Absolute or Differential. If the temperature is out of the working range of the unit,
then a Operand Error will occur.
 Note: This is an old style SR-80 command. It is not recommended for use in new
applications. It is replaced by SetTemperature.
 Reference Command: SetTemperature
S T
Space
TemperatureValue
EOM
 SR-80 command format compliance.
 Input Operand: TemperatureValue - This is the desired set point value of the
temperature. It is a numeric value with up to 3-digit decimal point accuracy.
 Return Values: None.
605-7040 Operation Manual
Rev D 6-24
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com