CI Systems ControlMaster SR-800R - Page 120

CI Systems SR-800R
6.2.30 RR
 Summary: This command is used to get the radiometric offset value. This value
has meaning only if the SetMode is 3, i.e., differential with radiometric offset.
 Reference Command: SetMode, GetMode
R R
EOM
 SR-80 command format compliance.
 Return Values: RadiometricOffset - returns the current offset value with 3-digit
accuracy.
6.2.31 SR
 Summary: This command is used to set the radiometric offset value. This value
has meaning only if the SetMode is 3, i.e., differential with radiometric offset.
 Reference Command: SetMode, GetMode
S R dRadiometricOffset
EOM
 SR-80 command format compliance.
 Input Operand: dRadiometricOffset - set the current offset value with 3-digit
accuracy. The range is between (+/-) 1 Degrees.
605-7040 Operation Manual
Rev D 6-25
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com