CI Systems SR-800R
5. If GPIB is selected, select the SR-800R Port # from the Port drop-down list
(Dev10 in this example, the default Port #; it should be identical to the settings
you made to the SR-800R according to Section 3.2.3.6.3: Communications):
Figure 9-3: GPIB Communication Setup
6. If RS232 is selected, select the COM # that is hard wired from the PC to the SR-
800R (it should be identical to the settings you made to the SR-800R according to
Section 3.2.3.6.3: Communications):
7. Click to apply your changes and to perform a communication with
the SR-800R. A dialog-box opens prompting you to re-approve your settings.
Click OK.
605-7040 Operation Manual
Rev D 9-4
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...