CI Systems SR-800R
4. Pull out the Emitter Sensor from its port using the dedicated jig:
Figure 7-4: Emitter Sensor Replacement (typical)
NOTE
The inserted sensor is held in place by way of a built-in
magnet; therefore, a reasonable force is required to separate the
sensor from its port.
5. Remove the sensor and store it in its package to avoid damage.
605-7040 Operation Manual
Rev D 7-4
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...