CI Systems SR-800R
9. Operating the SR-800R via the Remote
Control Program
This chapter provides step-by-step instructions on how to use the SR-800R Remote
Control program.
9.1 Overview
With the Blackbody Remote Control program you can setup and operate the SR-800R
by using a standard PC and via a communication protocol.
With the Blackbody Remote Control program you can:
Setup the PC-to-SR-800R communication protocol
Control a Blackbody Temperature and Mode (either Absolute or Differential)
Control Target Wheel or stage and select target/stage
Control up to seven general purpose I/O ports (five outputs and two inputs)
9.2 Installing the SR-800R Remote Control Program
1. Launch the installation CD of the Blackbody Remote Control program.
2. Follow the prompts. Upon completion, a shortcut is added to the Start menu and
the Blackbody Remote Control program icon is added on your Desktop.
605-7040 Operation Manual
Rev D 9-1
June 2013
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...